HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Release Notes, March 2009

Table 1-1 Fibre Channel Driver Version History (continued)
HP-UX 11i v3.0HP-UX 11i v2.0HP-UX 11i v1.6HP-UX 11i v1HP-UX 11.00Release
B.11.31.0811 (64-bit)Web Release
0811
B.11.31.0903 (64-bit)B.11.23.0903
(64-bit)
B.11.11.18 (32-bit
or 64-bit)
Application
Release 0903
What is New in This Version
This version of the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver contains only defect fixes
and does not offer any new feature. For information about the defect fixes, see “Defects Fixed in
This Release”.
Installation Prerequisites
You must install the Fibre Channel Mass Storage (FCMassStorage) software before installing the
FibrChanl-00 HP PCI Tachyon TL/TS/XL2 Fibre Channel driver on the system.
The FCMassStorage driver is available for download at:
http://h20293.www2.hp.com/
http://itresourcecenter.hp.com
Installing the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver
To install the FibrChanl-00 HP PCI Tachyon TL/TS/XL2 Fibre Channel driver on an HP-UX 11i
v3 system, complete the following steps:
1. Log in to the HP-UX 11i v3 system as superuser.
2. Download the HP-UX 11i v3 depot in the /tmp directory on your system.
3. Verify whether the HP-UX 11i v3 depot is downloaded successfully.
To verify whether the HP-UX 11i v3 depot is downloaded successfully, enter the following
command at the HP-UX prompt:
# swlist -d @ /tmp/<11.31_depot>
The following information is displayed:FibrChanl-00 B.11.31.0903 FibreChannel;
HW=A6795A, A5158A
4. To install the HP Tachyon TL/TS/XL2 Fibre Channel driver on the HP-UX 11i v3 system,
enter the following command at the HP-UX prompt:
# swinstall -x autoreboot=true -s /tmp/<11.31_depot> FibrChanl-00
The following message is displayed:
Execution Phase Succeeded
Removing the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver
To remove the FibrChanl-00 HP PCI Tachyon TL/TS/XL2 Fibre Channel driver from an HP-UX
11i v3 system, enter the fo llowing command at the HP-UX prompt:
# swremove -x autoreboot=true FibrChanl-00
The following message is displayed:
Execution Phase succeeded
Reinstalling the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver
To reinstall the HP Tachyon TL/TS/XL2 Fibre Channel driver on an HP-UX 11i v3 system, enter
the following command at the HP-UX prompt:
What is New in This Version 7