HP 3PAR Citrix Implementation Guide

5. To verify that the parameter is set correctly, issue the following command:
# ./hbacmd GetDriverParam <Port WWN>
Output from the foregoing commands is shown below:
# ./hbacmd ListHBAs
Manageable HBA List
Port WWN : 10:00:00:00:c9:7b:07:52
Node WWN : 20:00:00:00:c9:7b:07:52
Fabric Name: 10:00:08:00:88:a0:5c:ad
Flags : 8000f100
Host Name : sqa-dl380g5-08
Mfg : Emulex Corporation
Serial No. : VM82281959
Port Number: 0
Mode : Initiator
. . .
# ./hbacmd Help DriverParams
. . .
SetDriverParam <WWPN> <Flag1> <Flag2> <Param> <Value>
Flag1: {L G}
L: Local (i.e. this adapter only)
G: Global (i.e. all adapters on this host)
Flag2: {P T}
P: Permanent (i.e. Persists across reboot)
T: Temporary
Param: Name of parameter whose value is to be set
Value: Input as decimal, prefix with 0x to input as hex
. . .
./hbacmd SetDriverParam 10:00:00:00:c9:7b:07:52 G P nodev-tmo 1
# ./hbacmd GetDriverParams 10:00:00:00:c9:7b:07:52
Driver Params for 10:00:00:00:c9:7b:07:52. Values in HEX format.
DX string Low High Def Cur Exp Dyn
00: log-verbose 0 ffff 0 0 1 1
01: lun-queue-depth 1 80 1e 1e 1 2
02: scan-down 0 1 1 1 1 2
03: nodev-tmo 0 ff 1e 1 1 1
04: topology 0 6 0 0 1 2
05: link-speed 0 8 0 0 1 2
06: fcp-class 2 3 3 3 1 2
. . .
Installing the QLogic HBA/CNA
Install the QLogic host bus adapter(s)/converged network adapter(s) in the host based on the
documentation provided with the HBAs/CNAs and host.
20 Connecting a Host with Fibre Channel/FCoE