HP 3PAR HP-UX Implementation Guide

The drivers are installed with the operating system. FibreChanl-00 must be installed
for FibrChanl-01 to work.
2. Verify that the OnlineDiag or Support Tools Bundle software is installed and install
the software if it is not present. The OnlineDiag bundle is present in the OS media.
# swlist Online*
# OnlineDiag B.11.31.04.05 HPUX 11.31 Support Tools Bundle, September 2008
3. HP recommends that the server be at a certain firmware version to detect the fibre channel
cards. Verify the firmware version using the MP interface on the Integrity or HP 9000 Server.
MP:CM> SYSREV
FIRMWARE:
Core IO
Master : A.006.012
Event Dict. : 1.009
Slave : A.006.012
Event Dict. : 1.009
Cell 0
PDHC : A.003.023
Pri SFW : 22.002 (PA)
Sec SFW : 1.025 (IA)
Cell 1
PDHC : A.003.023
Pri SFW : 22.002 (PA)
Sec SFW : 1.025 (IA)
Alternately, if Online Diagnostics are installed, run the cstm tool to find the firmware version.
a. Run the Support Tools Manager (STM) utility cstm.
# /usr/sbin/cstm
b. Use the selall and il commands to find all the required system information.
# cstm>selall
cstm>il
...
Product ID : ia64 hp server rx7620
Product Number : not set
System Firmware Revision : 001.025
BMC Revision : v06.12
System Serial Number: : not set
System Software ID : 3801066248
NOTE: Contact HP for information on upgrading the system firmware.
c. For Itanium systems, install the supported EFI firmware for all supported HBAs. Download
the firmware from the HP Support Center by searching for your HBA model. Those firmware
versions are essential to enable the boot over SAN feature.
16 Connecting a Host Server with Fibre Channel