HP 3PAR HP-UX Implementation Guide

Common Service parameters (all values shown in hex):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Common Features : 8800 RO_Bitmap: ffff
Total Conseq: ff
Class 3 Service parameters (all values shown in hex):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Open Sequences/Exchg: 1 Conseq: ff
Recipient Control Flags: 0 Rxsz: 800
Target N_Port_id is = 0x031300
Target state = DSM_UNOPENED
Symbolic Name = 3PAR
Port Type = N_PORT
FCP-2 Support = NO
Target Port World Wide Name = 0x20240002ac000e2c
Target Node World Wide Name = 0x2ff70002ac000e2c
Common Service parameters (all values shown in hex):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Common Features : 8800 RO_Bitmap: ffff
Total Conseq: ff
Class 3 Service parameters (all values shown in hex):
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Open Sequences/Exchg: 1 Conseq: ff
Recipient Control Flags: 0 Rxsz: 800
5. To find the storage serial number for the corresponding disk id on the HP-UX host, use thecstm
command. The HP Online diagnostic tool must be installed to access the cstm command. For
example:
# cstm
# selclass type disk
# info
# infolog
. . .
Hardware path: 0/2/0/0.8.0.0.0.0.4
The selected device is not supported by this tool.
Inaccurate information could be displayed by the tool.
Product Id: VV Vendor: 3PARdata
Device Type: SCSI Disk Firmware Rev: 0000
Device Qualifier: 3PARdataVV Logical Unit: 4
Serial Number: 003B003E
Capacity (M Byte): 4096.00
Block Size: 512
Max Block Address: 8388607
. . .
Check the ioscan -fun disk for the given hardware path and use the HP 3PAR StoreServ
Storage CLI command showvlun -lvw or showvv -d to get the volume name. The data
which matches is in bold font:
# showvlun -lvw -host <hostname>
. . .
Active VLUNs
Lun VVname -----VV_WWN----- Host ----Host_WWN---- Port Type
4 hpuxN.0 50002AC0003B003E hp 50060B0000101A4C 1:0:3 host
Setting Up Multipathing Software on HP-UX 11i v2 37