HP 3PAR SmartStart 1.1 User's Guide (QL226-96476, December 2012)

NOTE: Verify the folder you mount is empty. If the folder does not exist, is not empty,
or is read-only, the folder might not mount successfully.
4. Click Next.
Adding virtual volumes to Windows might take up to 10 minutes.
Troubleshooting Task Completion
If SmartStart displays the message Failed to validate whether the current Windows task is complete,
use one of the following suggestions to try the task again:
• Click the Prev button, then click Next.
• Cancel and then restart the wizard.
If the problem persists, contact HP support. For more information, see “Support and Other Resources”
(page 50).
Summary: Add Virtual Volumes to Windows Wizard
1. Review your virtual volume disk device setup.
2. Click Finish.
Troubleshooting Task Completion
If SmartStart displays the message Failed to validate whether the current Windows task is complete,
click Finish again.
If the problem persists, contact HP support. For more information, see “Support and Other Resources”
(page 50).
Add Virtual Volumes to Windows 31