HP 3PAR Windows 2012 and Windows Server 2008 Implementation Guide

8. Perform Step 4 through Step 7 to add the connection to the second target portal. The iSCSI
Initiator Properties window shows the status of both; see “Verifying Connected Status for Both
Targets ” (page 44).
Figure 14 Verifying Connected Status for Both Targets
Configuring Host and Target CHAP
This section contains procedures for configuring the Challenge-Handshake Authentication Protocol
(CHAP) and removing it, in separate subsections:
• “Setting Host CHAP” (page 44)
• “Setting Target CHAP” (page 46)
• “Setting Mutual (Bidirectional) CHAP” (page 48)
• “Removing CHAP” (page 48)
Setting Host CHAP
To set a host CHAP secret, configure it on both the HP 3PAR StoreServ Storage server and the
Windows Server 2012/2008 host. Follow these steps:
1. Make sure that an iSCSI host definition has been created on the HP 3PAR StoreServ Storage.
44 Setting Up a Windows Server 2012 or 2008/HP 3PAR StoreServ Storage Configuration with iSCSI Storage