HP 3PAR Windows 2012 and Windows Server 2008 Implementation Guide

5. In the iSCSI Initiator Properties window, click the Targets tab. In the Targets tab, choose the
targets where the CHAP applies. Click Connect from Connect to Target, then check the Enable
multi-path and click the Advanced... button. From the Advanced Settings windows, follow
these steps, as shown in “Setting Up the Target CHAP Secret for HP 3PAR StoreServ Storage
initchap” (page 46):
a. Set Microsoft iSCSI Initiator for Local adapter
b. Select Initiator IP
c. Select Target Portal IP
d. Check Enable CHAP log on box
e. Enter CHAP secret for Target secret
NOTE: Enter MyChapSecret (from the example in Step 3) at the Target secret field.
See “Setting Up the Target CHAP Secret for HP 3PAR StoreServ Storage initchap”
(page 46).
Figure 15 Setting Up the Target CHAP Secret for HP 3PAR StoreServ Storage initchap
Setting Target CHAP
To set a target CHAP secret, configure it on both the HP 3PAR StoreServ Storage and the Windows
Server 2012/2008 host by following these steps:
46 Setting Up a Windows Server 2012 or 2008/HP 3PAR StoreServ Storage Configuration with iSCSI Storage