HP 3PAR Windows 2012 and Windows Server 2008 Implementation Guide

3. In the iSCSI Initiator Properties window, click the Targets tab where the CHAP applies; click
the Connect button from the Connect to Target window and check the Enable multi-path option.
Then click the Advanced... button and in the Advanced Settings window, follow these steps,
as shown in “Removing CHAP” (page 49):
a. Set Microsoft iSCSI Initiator for Local adapter.
b. Select Initiator IP
c. Select Target portal IP
d. Clear the Enable CHAP log on check box.
Figure 17 Removing CHAP
Establishing a Connection with a Hardware iSCSI Initiator
As of HP 3PAR OS 3.1.2.x, the HP 3PAR StoreServ 7000 Storage and HP 3PAR StoreServ 10000
Storage introduces support for hardware iSCSI on Windows Server 2012, Windows Server 2012
R2, and Windows Server 2008 R2 SP1 with supported converged network adapters (CNAs). For
more information about supported configurations, see the HP SPOCK website:
HP SPOCK
This section describes the basic hardware iSCSI configuration using a CN1100E. For further
configuration information or a different CNA type, see vendor specific documentation.
Establishing a Connection with a Hardware iSCSI Initiator 49