HP 3PAR Windows 2012 and Windows Server 2008 Implementation Guide

7 Configuring the Windows Server 2012/2008 Host as

an FCoE Initiator

This chapter describes the procedures for setting up a Windows Fibre Channel over Ethernet (FCoE)

configuration with an HP 3PAR StoreServ Storage. These instructions cover both end-to-end FCoE

and FCoE initiator to FC target.

Windows Host Requirements

The Windows host needs to meet the following software requirements:

• Obtain the supported level of CNA BIOS and firmware from:

• Obtain the supported level of CNA drivers from:

HP Support

• Install the Emulex OneCommand Manager, the Qlogic QConvergeConsole Manager or

Broadcom Advanced Control Suite (BACS) from:

HP Support

For specific details of supported configurations, consult the HP SPOCK website:

HP SPOCK

Configuring the FCoE Switch

Connect the Windows (FCoE Initiator) host ports and HP 3PAR StoreServ Storage server (FCoE

target) ports to an FCoE-enabled switch.

NOTE: FCoE switch VLANs and routing setup and configuration is beyond the scope of this

document. Consult your switch manufacturer's documentation for instructions of how to set up

VLANs and routing.

58 Configuring the Windows Server 2012/2008 Host as an FCoE Initiator