HP 3PAR T-Class Installation and Deinstallation Guide

2. From the console menu, select option 1 for Out of The Box Procedure.
3PAR Console Menu 1400293-1 3.1.1.xxx
1. Out Of The Box Procedure
2. Run ootb-stress-analyzer
3. Re-enter network configuration
4. Update the CBIOS
5. Enable or disable CLI error injections
6. Perform an IDE rescue
7. Set up the system to wipe and rerun ootb
8. Cancel a wipe
9. Perform a deinstallation
10. Update the system for recently added hardware (admithw)
11. Check system health (checkhealth)
12. Exit
WARNING! Proceeding with the system setup script causes complete and irrecoverable loss
of data. Do not perform this procedure on a system that has already undergone the system
setup described in this chapter.
NOTE: At some point during this process, you may receive a message to indicate the caching
limit for power fail is set to 0 pages. This is normal during initialization and does not require
any action.
NOTE: If you quit this setup script at any point, you must repeat the entire process.
When the system is ready for the system setup script, the following message appears:
It appears your Cluster is in a proper manual startup state to proceed.
Welcome to the Out-Of-The-Box Experience 3.1.1.xxx
***************************************************************************
***************************************************************************
* *
* CAUTION!! CONTINUING WILL CAUSE COMPLETE AND IRRECOVERABLE DATA LOSS *
* *
***************************************************************************
***************************************************************************
You need to have the InServ network config information available.
This can be obtained from the Systems Assurance Document.
DO YOU WISH TO CONTINUE? yes/no ==> yes
Cluster has the following nodes:
Node 0
Node 1
Enter < C > to continue or < Q > to quit ==> c
• Verify the number of controller nodes in the system, then type c and press ENTER.
• If the system is not ready for the system setup script, an error message appears. After
following any onscreen instructions and correcting any problems return to Step 2 and
attempt to run the setup script again.
Setting Up the Storage System 93