HP 3PAR VMware ESX Implementation Guide

Figure 11 CN1100E BIOS
4. Ensure that your CNA is not configured for Independent Hardware iSCSI.
NOTE: These steps are specific to the CN1100E. Different vendors employ different methods
of implementing Dependent Hardware iSCSI. See vendor documentation for vendor-specific
procedures.
a. On the CN1100E, press Ctrl S to enter the BIOS.
b. Select Controller Configuration.
c. Select your controller port.
d. Select Erase Configuration, as shown in Figure 12 (page 27):
Figure 12 Erase Configuration
5. When the ESXi host is booted, from vCenter, click your host and then click the Configuration
tab.
Hardware iSCSI Support 27