HP 3PAR VMware ESX Implementation Guide

Figure 15 General Properties
9. Enter the IP address for your Subnet Mask and Default Gateway, and then click OK.
10. Click the Dynamic Discovery tab, and then click Add (Figure 16 (page 29)).
Figure 16 Dynamic Discovery
11. Enter the IP address of your HP 3PAR StoreServ Storage and click OK.
12. Repeat for each HP 3PAR StoreServ Storage port you want this initiator port to access.
13. Click the Static Discovery tab and verify that each HP 3PAR StoreServ Storage port added
appears, as in the example in Figure 17 (page 30).
Hardware iSCSI Support 29