HP StorageWorks EVA Cluster Extension Software Administrator Guide (T3667-96045, April 2010)

2. Select a DR group, and then click OK.
NOTE:
When using Command View EVA 8.0.2 or later, if you created new DR groups, the groups
might not show up immediately in the Select DR Group dialog box. To make a new DR
group available in the EVA Cluster Extension GUI, do one of the following:
• Wait 30 minutes after creating the DR group.
• Restart the HP StorageWorks CIM Object Manager service after creating the DR group.
This service must be restarted on all Command View servers configured for the EVA
Cluster Extension resource.
• Run CLIRefreshTool.bat for both arrays. This tool, located in the Install Path\
Hewlett-Packard\SMIS\CXWSCimom\bin directory, is installed with HP SMI-S
EVA. This tool must be run on all Command View servers configured for the EVA Cluster
Extension resource. See the SMI-S EVA documentation for more information.
3. Click Apply to finish your modifications and leave the window open, or OK to save your changes
and close the Properties window.
Changing DR group settings
The cluster software resource configuration GUI and the resource configuration tool display the DR
group name, write mode, and failsafe mode. Use the cluster software Parameters tab or the resource
configuration tool to edit the advanced DR group settings to control failover behavior for the DR group
that you use with EVA Cluster Extension.
1. Click Advanced Settings.
The Advanced settings dialog box appears.
Configuring EVA Cluster Extension for Windows42