HP StorageWorks EVA Cluster Extension Software Administrator Guide (T3667-96045, April 2010)

NOTE:
When you configure EVA Cluster Extension resource properties using the CLI, the properties you enter
are not validated, so you must enter the property values accurately, and verify them against the EVA
Cluster Extension documentation.
You can display all attributes of the EVA Cluster Extension resource clx_fileshare with the following
command:
cluster resource clx_fileshare /privprop
The following example changes the CSObjectPathA property for the resource clx_fileshare:
cluster resource clx_fileshare /privprop CSObjectPathA=
"HPEVA_ConsistencySet.InstanceID=""50001FE15002B5A0.6005-08b4-
0001-2b69-0000-6000-86a0-0000"""
To retrieve the values for CSObjectPathA and CSObjectPathB, you must create and configure a
UCF.cfg file for this DR group and run the clxconf -smis command. The values for both objects
are stored in the clxobjpaths.cfg file.
NOTE:
This step is not necessary when using the Cluster Administrator or Failover Cluster Management GUI.
The following example changes the name of EVA Cluster Extension resource EVA Cluster
Extension resource1 to EVA Cluster Extension resource2:
cluster resource "EVA Cluster Extension resource1" /ren:"EVA Cluster Extension resource2"
Setting EVA Cluster Extension properties using a UCF
You can use a UCF to configure certain EVA Cluster Extension properties for Windows.
Properties that you can configure in a UCF include:
• LogLevel
• ClusterNotifyCheckTime
• ClusterNotifyWaitTime
• DataSyncTimeout
• MergeCheckInterval
• StatusRefreshInterval
IMPORTANT:
If you plan to use the default values for these properties, no UCF is required.
To configure properties using a UCF:
1. Take the EVA Cluster Extension resource offline.
EVA Cluster Extension Software Administrator Guide 45