HP StorageWorks XP Cluster Extension Software Administrator Guide (T1656-96035, April 2010)

clxHACMP: ERROR - Pair state of device group "oracle" might be
clxHACMP: ERROR - incorrect. Manual checking and correction within
clxHACMP: ERROR - Continuous Access XP is required.
clxHACMP: ERROR - Remove file "/etc/opt/hpclx/OracleRG.LOCK" in order
clxHACMP: ERROR - to continue with HACMP specific recovery actions.
=================================================================
The last message is repeated every 5 minutes. XP Cluster Extension will stop any further processing
until the you remove the application_name.LOCK file to transfer control back to HACMP. This
enables you to check the status of the data on each copy and decide whether it is safe to continue
or not.
Depending on the amount of time needed for checking the configuration and the XP disk pair status,
the HACMP timeout could be reached. This will automatically cause the event config_too_long
to be called by HACMP. The following message will appear in the log file /tmp/hacmp.out:
WARNING: Cluster MYCLUSTER has been running recovery program '/usr/es/sbin/cluster/
events/node_up.rp' for 1110 seconds.
Please check cluster status.
If you think the XP Cluster Extension configuration is correct, and the XP disk pair status allows you
to manually continue the process for starting the application, remove the application lock file /etc/
opt/hpclx/oracle.LOCK mentioned in the previous error message.
When this file has been removed, XP Cluster Extension transfers control back to HACMP. The event
get_disk_vg_fs and all the subsequent events within the main event node_up_local will be
processed. Because XP Cluster Extension as a pre-event of get_disk_vg_fs has produced an error,
the main event node_up_local will fail as well. The following HACMP event event_error will be
called:
node_up_local[30] [ 0 -ne 0 ]
node_up_local[8] exit 1
Dec 15 17:07:17 EVENT FAILED:1: node_up_local
node_up[326] [ 1 -ne 0 ]
node_up[328] cl_log 650 node_up: Failure occurred while processing Resource Group
OracleRG. Manual intervention required. node_up OracleRG
***************************
Dec 15 2000 17:07:17 !!!!!!!!!! ERROR !!!!!!!!!!
***************************
Dec 15 2000 17:07:17 node_up: Failure occurred while processing Resource Group
OracleRG. Manual intervention required.
node_up[329] STATUS=1
node_up[337] [ AIX1 != AIX1 ]
node_up[356] exit 1
Dec 15 17:07:18 EVENT FAILED:1: node_up AIX1
To continue any further processing of HACMP, you must invoke the HACMP command clruncmd to
recover from the status event_error.
Example
# clruncmd aix1
This will bring the cluster into normal status again. All subsequent events (for example,
node_up_complete) will be processed.
Troubleshooting152