HP StorageWorks XP Cluster Extension Software Administrator Guide (T1656-96035, April 2010)

5. Click OK to save the information and close the configuration tool. The configuration information
is saved to the ClxXPCfg file.
NOTE:
XP Cluster Extension provides an XP RAID Manager service, which automatically starts XP
RAID Manager instances at system boot time. This feature reduces resource group and
service and application failover times because the XP Cluster Extension resource does not
need to start the XP RAID Manager instances. When you click Apply or OK in the
configuration tool, the XP RAID Manager service is started.
6. Use the procedures in “Importing and exporting configuration information” on page 41 to copy
the ClxXpCfg file to the other cluster nodes.
Defining XP Cluster Extension configuration information using the CLI
You can configure XP Cluster Extension with the CLI command CLXXPCONFIG. Enter CLXXPCONFIG
-?, CLXXPCONFIG /?, or CLXXPCONFIG /help to view usage information.
1. Enter CLXXPCONFIG -I to open the configuration tool.
2. The pair/resync monitor monitors the disk pair status if the ResyncMonitor attribute is set to YES,
and resynchronizes disk pairs if the ResyncMonitorAutoRecover attribute is set to YES. By default,
the pair/resync monitor uses port 5307.
To change the pair/resync monitor port, enter CLXXPCONFIG PRM /PORT=value, where
value is the port number you want to use.
NOTE:
To view the pair/resync monitor port, enter CLXXPCONFIG PRM.
Configuring XP Cluster Extension for Windows40