HP XP Cluster Extension Software Administrator Guide

NOTE: The service name clxmonitor is appended with the text “(not configured)” unless the
port number is configured in the configuration tool.
Defining HP XP Cluster Extension configuration information using the GUI
1. Open the configuration tool. For instructions, see “Starting the HP XP Cluster Extension
configuration tool” (page 14).
2. The pair/resync monitor monitors the disk pair status if the ResyncMonitor attribute is set to
YES, and resynchronizes disk pairs if the ResyncMonitorAutoRecover attribute is set to YES.
By default, the pair/resync monitor uses port 5307.
To use a port other than 5307, enter the desired port number in the Port box. The range of
available ports is 1024 through 65535. The pair/resync monitor port value must be the same
on all cluster nodes.
Configuring HP XP Cluster Extension 15