3PAR InForm® OS 2.2.4 Messages and Operator's Guide (320-200119 Rev A, March 2009)

7.19
Using the Component LEDs
InForm OS Version 2.2.4
3PAR Confidential
Table 7-6 on page 7.19 contains descriptions of all LED combinations for the QLogic Fibre
Channel port LED pairs. Consult this table to verify proper functioning of Fibre Channel ports
for QLogic HBAs.
7.1.3.2 LSI Logic Fibre Channel Port LEDs
The LSI Logic Fibre Channel adapters in the InServ S-Class Storage Server controller nodes also
contain Fibre Channel port LEDs. The LSI Logic adapters are available in either two-port or
four-port models (Figure 7-10) and (Figure 7-11).
Table 7-6. Fibre Channel Port Status LED Indications (QLogic 2-Port)
Green LED (left) Amber LED (right) Port status
On On Port has power.
On Off Port is connected and online.
Off On Port is receiving signal.
Off Flashing Cable disconnected or loss of
synchronization.
Flashing Flashing Firmware error.
NOTE: For the dual-port Fibre Channel adapters pictured in Figure 7-10, there is a
provision for a third LED to the right of the LEDs for P
ORT 2; however, no LED
occupies this space.