3PAR InForm® OS 2.2.4 Messages and Operator's Guide (320-200119 Rev A, March 2009)

11.11
InForm OS Version 2.2.4
3PAR Confidential
MESSAGE CODE
0x400fa
TYPE
Component state change
MESSAGE
VV <vv_id>(<vvname>) Failed (<list of states>)
STATE 1
LDs Not Started
SUGGESTED ACTION
The VV specified in the alert has not been started by the system due to some of the underlying
LDs are not in the 'normal' state. Use the CLI command
showvv <vvname> to confirm that the
VV is still in this state.
Use the CLI command
showld -vv <vvname> to see which LDs are not in the 'normal' state.
Most of the time, LDs are not in the normal state because some nodes, drive cages, or PDs are
off-line.
Contact your local service provider for technical support and services.
STATE 2
Needs Checking
SUGGESTED ACTION
The VV specified in the alert has not been started by the system because it needs a consistency
check to be run on it. Use the CLI command
showvv <vvname> to confirm that the VV is still
in this state.
To run the consistency check, use the CLI command
checkvv. After a successful check, the VV
will transition to the 'normal’ state.
NOTE: Prior to running a consistency check:
1 Run the CLI command
showvv to confirm the VV is still in this state.
2 Run the CLI command
showld -vv <vvname> to confirm that all the underlying
LDs are in the ‘normal state.