3PAR InForm® OS 2.2.4 Messages and Operator's Guide (320-200119 Rev A, March 2009)

11.80
InForm OS Version 2.2.4
3PAR Confidential
MESSAGE CODE
0x1e0001
TYPE
Cage log alerts
MESSAGE 1
Midplane FPGA_<fpga> ESI<port> <failure type> failure: <code>.
SUGGESTED ACTION
Internal midplane hardware error. One or more communication channels has been disabled.
Replace midplane.
MESSAGE 2
Midplane FPGA_<fpga> IRQ rate too high: <code>.
SUGGESTED ACTION
Internal midplane hardware error. Two or more communication channels have been disabled.
Hard reset cage using InForm UI. If error persists, replace midplane.
MESSAGE 3
Midplane FPGA_<fpga> FPGA Downrev: <rev>.
SUGGESTED ACTION
An older version of FPGA firmware was detected. Replace midplane.
MESSAGE 4
Miplane FPGAs FPGA Revision Mismatch: <code>.
SUGGESTED ACTION
Internal midplane hardware error. All communication channels have been disabled. Replace
midplane.
MESSAGE 5
Midplane FPGA_<fpga> Revision unknown: <rev>.
SUGGESTED ACTION
Internal midplane hardware error. Two or more communication channels have been disabled.
Replace midplane.