3PAR InForm® OS 2.2.4 Messages and Operator's Guide (320-200119 Rev A, March 2009)

11.10
InForm OS Version 2.2.4
3PAR Confidential
MESSAGE CODE
0x1f000fa
TYPE
Component state change
MESSAGE
Disk <wwn_id> Failed (<list of states>)
STATE 1
Invalid
SUGGESTED ACTION
The PD specified in the alert has been marked failed. Use the CLI command showpd <pd_id>
to confirm that the disk is still in this state.
The PD can be marked
Invalid because of a number of reasons. A reason code along with
Invalid will give more information about why the PD was marked Invalid.
If there is no reason code associated with this, contact your local service provider for technical
support and services.
STATE 2
Inquiry Failed
SUGGESTED ACTION
The PD specified in the alert has been marked failed because a SCSI inquiry to it failed. Use the
CLI command
showpd <pd_id> to confirm the disk is still in this state.
A disk is marked failed because a SCSI inquiry to it failed to gather information about its serial
number, device ID, vendor ID, etc. Generally this alert is auto-fixed when the SCSI inquiry is
retried.
Wait for a few minutes to see if the alert is auto-fixed. If that does not happen, contact your
local service provider for a possible disk replacement.
STATE 3
Unit Ready Failed