3PAR InForm® OS 2.2.4 Messages and Operator's Guide (320-200119 Rev A, March 2009)

6.8
Using the Component LEDs
InForm OS Version 2.2.4
3PAR Confidential
Disk status Quick flashing, or 20
percent-on and 80 percent-
off green light
Indicates disk is not spun up but
is functioning.
Steady green light Indicates that the disk is spun up
and waiting for a command.
Flashing green light Indicates that the disk is
executing commands.
No light Indicates no disk is present.
Steady amber light Indicates a disk error, or the disk
is bypassed on both paths
(loops).
DC4 Hot-plug Steady amber light
(depending on hardware
version).
When illuminated, the drive
magazine is prepared for
replacement (hot-plug).
No light Indicates magazine is not
prepared for hot-plug.
Flashing amber light Indicates drive magazine error.
Contact your local service
provider for technical support
and services.
Table 6-2. Drive Magazine LED Displays (continued)
LED Appearance Meaning
NOTE: After powering on, allow approximately two minutes for the disks on the
DC4 drive magazine to spin up before checking the drive magazine LEDs.