HP 3PAR InForm OS 3.1.1 Messages and Operators Guide

MESSAGE CODE
0x00400fa
TYPE
Component state change
MESSAGE
VV <vv_id>(<vvname>) Failed (<list of states>)
STATE 1
LDs Not Started
SUGGESTED ACTION
The VV specified in the alert has not been started by the system due to some of the underlying LDs
are not in the 'normal' state. Use the CLI command showvv <vvname> to confirm that the VV is
still in this state.
Use the CLI command showld -vv <vvname> to see which LDs are not in the 'normal' state.
Most of the time, LDs are not in the normal state because some nodes, drive cages, or PDs are
offline.
Contact your local service provider for technical support and services.
STATE 2
Needs To Be Checked
SUGGESTED ACTION
Contact your local service provider for technical support and services.
STATE 3
Snapdata Invalid
SUGGESTED ACTION
The VV specified in the alert has snapshots that cannot be started up because the snapshot data
is invalid.
Contact your local service provider for technical support and services.
STATE 4
Preserved
SUGGESTED ACTION
The VV specified in the alert is in a cache-preserved mode because there are some I/O errors on
the underlying LDs. Use the CLI command showvv <vvname> to confirm that the VV is still in this
state. Use the CLI commands showld -vv <vvname> and showpd to obtain additional data
on the underlying errors. Once these errors are fixed, the VV will transition automatically to the
'normal' state.
Contact your local service provider for technical support and services.
STATE 5
Stale
107