HP 3PAR InForm OS 3.1.1 Messages and Operators Guide

MESSAGE CODE
0x01e0001
TYPE
Cage log event
MESSAGE 1
cage<cage_id<side>, port <up to four node:slot:port tuples>, cage time
<time_event>. Internal parameters: <error_code> <error_flag> <additional
parameters>.
SUGGESTED ACTION
An internal midplane hardware error has occurred. One or more communication channels have
been disabled. Replace the midplane.
Contact your authorized support provider for assistance if required.
MESSAGE 2
Midplane FPGA_<fpga> IRQ rate too high: <code>.
SUGGESTED ACTION
An internal midplane hardware error has occurred. Two or more communication channels have
been disabled due to an excessive IRQ rate.
Contact your authorized support provider for assistance if required.
MESSAGE 3
Midplane FPGA_<fpga> FPGA Downrev: <rev>.
SUGGESTED ACTION
An older version of FPGA firmware was detected. Replace the midplane.
Contact your authorized support provider for assistance if required.
MESSAGE 4
Miplane FPGAs FPGA Revision Mismatch: <code>.
SUGGESTED ACTION
An internal midplane hardware error has been detected. There is a mismatch between FPGA
revision levels. All communication channels have been disabled. Replace the midplane.
Contact your authorized support provider for assistance if required.
MESSAGE 5
Midplane FPGA_<fpga> Revision unknown: <rev>.
SUGGESTED ACTION
An internal midplane hardware error has been detected. There is a mismatch between FPGA
revision levels. All communication channels have been disabled. Replace the midplane.
Contact your authorized support provider for assistance if required.
186 Alerts