HP 3PAR InForm OS 3.1.1 Messages and Operators Guide
MESSAGE CODE
0x01f00fa
TYPE
Component state change
MESSAGE
Disk <wwn_id> Failed (<list of states>)
STATE 1
Invalid
SUGGESTED ACTION
The PD specified in the alert has been marked failed. Use the CLI command showpd <pd_id>
to confirm that the disk is still in this state.
The PD can be marked Invalid because of a number of reasons. A reason code along with
Invalid will give more information about why the PD was marked Invalid.
Contact your local service provider for technical support and services.
STATE 2
Inquiry Failed
SUGGESTED ACTION
The PD specified in the alert has been marked failed because a SCSI inquiry to it failed. Use the
CLI command showpd <pd_id> to confirm the disk is still in this state.
A disk is marked failed because a SCSI inquiry to it failed to gather information about its serial
number, device ID, vendor ID, etc. Generally this alert is auto-fixed when the SCSI inquiry is retried.
Wait for a few minutes to see if the alert is auto-fixed.
Contact your local service provider for technical support and services.
STATE 3
Unit Ready Failed
SUGGESTED ACTION
The PD specified in the alert has been marked failed because a command sent to check if disk is
ready has failed. Use the CLI command showpd <pd_id> to confirm the disk is still in this state.
The failure could be intermittent and a retry might fix it. As above, the suggested action is to wait
for a few minutes to see if the alert is auto-fixed.
Contact your local service provider for technical support and services.
STATE 4
Read Capacity Failed
SUGGESTED ACTION
The PD specified in the alert has been marked failed because a command sent to read its capacity
has failed. Use the CLI command showpd <pd_id> to confirm the disk is still in this state.
214 Alerts