HP 3PAR InForm OS 3.1.1 Messages and Operators Guide

Table 12 Drive Cage DC4 FC-AL Module LED Displays (continued)
IndicatesAppearanceLED
high-level threshold, or a power supply
has failed.
The drive cage has some type of error,
such as a failed or missing power
Flashing amber light (1 blink per
second)
supply, but is communicating with a
node.
A cage firmware upgrade initiated by
the upgradecage CLI command is in
Rapid toggle between amber and
green light
progress. A firmware upgrade normally
takes less than two minutes to complete.
The FC-AL module is prepared for hot
plug replacement.
Steady amber lightHot plug
The FC-AL module is not prepared for
the hot plug.
No light
The drive cage is split into two logical
portions.
Steady green lightSplit mode
The drive cage is not split.No light
The transfer rate is operating at 4GB/s.Steady green light4GB/s
The transfer rate is operating at 2GB/s.No light
Drive Magazine LEDs
NOTE: After powering on, allow approximately two minutes for the disks on the DC4 drive
magazine to spin up before checking the drive magazine LEDs.
Drive magazines contain the following LEDs (Figure 49 (page 50)):
Using the T-Class Component LEDs 49