HP 3PAR InForm OS 3.1.1 Messages and Operators Guide

2. Verify that the blue LED on the front of the SP is illuminated.
3. Verify that all drive chassis LEDs are solid green and all controller node status LEDs are blinking
green once per second.
Connecting to the Service Processor
Once you are connected to the SP, there are two SP user interfaces, SPOCC and SPMAINT, that
you can use to perform various administrative and diagnostic tasks to support of both the storage
system and the SP.
Refer to“Logging into the SP Onsite Customer Care Interface (SPOCC)” (page 92).
NOTE: Establishing a Secure Shell Session (SSH) is required when connecting the SP through
LAN (Ethernet). Refer to “Using PuTTY” (page 91).
Using a Serial Connection
To connect the maintenance PC to the SP using a serial connection, refer to the appropriate HP
3PAR Storage System Maintenance Manual, Connecting the Maintenance PC chapter.
Using an Ethernet Connection
To connect the maintenance PC to the SP through the private Local Area Network (LAN) using an
Ethernet cable, you must first configure the LAN settings on the maintenance PC.
You can connect the maintenance to the SP using an Ethernet cable. When you use an Ethernet
connection, you have to configure LAN settings on the maintenance PC (refer to Section (page 89))
and establish an SSH using PuTTY. Refer to Section (page 91).
To connect using an Ethernet connection:
88 Power Off/On Procedures