HP 3PAR InForm OS 3.1.1 Messages and Operators Guide

1. Unlock and open the rear door of the storage system cabinet.
If necessary, insert a red crossover Category 5 Ethernet cable (RJ45 to RJ45) into the proper
Ethernet port of the SP (ETH1), refer to the following figures.
Figure 85 Wintec Service Processor Ethernet Ports
Figure 86 Supermicro Service Processor Ethernet Ports
Figure 87 Supermicro II Service Processor Ethernet Ports
NOTE: The Supermicro and Wintec Service Processor Ethernet port (ETH0) corresponds with
the front NIC Port LED 1 and Ethernet port (ETH1) corresponds with the front NIC Port LED 2.
2. Connect the free end of the crossover Ethernet cable to the Ethernet port in the maintenance
PC.
3. Power on the maintenance PC.
4. Configure the LAN settings on the maintenance PC. See “Configuring the LAN Settings on the
Maintenance PC” (page 89).
Configuring the LAN Settings on the Maintenance PC
NOTE: For Windows Vista users, go to Control Panel > Network and Internet > Network
Connections and right-click on the Local Area Connection icon and select Properties. Once on the
Networking tab, skip to step 4.
1. Right-click the My Network Places desktop icon to open the shortcut menu and select Properties
.
2. In the Network and Dial-up Connections window, right-click the Local Area Connection icon
to open the Local Area Connections Properties menu.
3. Click Properties to open the Local Area Connection Properties dialog box (“Local Area
Connection Properties Dialog Box” (page 90)).
Connecting to the Service Processor 89