HP 3PAR Management Console 4.5.1 Software User Guide

After zoning is complete, click OK, and click Verify Configuration when you return to the Set Up
Connections screen.
NOTE: If NPIV peer ports were created, the NPIV port WWNs associated with each peer port
must be included in the same zone as the peer port WWN.
If the configuration is successful, click OK in the Verify Configuration dialog.
If the configuration was not successful, a message similar to the following displays:
Show Port WWNs
The Show Port WWNs window displays the source system's system host port WWNs and the
destination system’s peer port WWNs. Use this information to zone the peer ports to the host ports.
An expandable panel is associated with ports having NPIV ports created on them. Click the (+)
icon next to NPIV Ports to view a list of NPIV ports and WWN details.
Show Port WWNs dialog with NPIV ports:
Show Port WWNs dialog with no NPIV ports:
252 Using Peer Motion in HP 3PAR Management Console Manager