HP 3PAR Management Console 4.5.1 Software User Guide

DescriptionColumn
The state of the port. See “System and Component Status Icons” (page 507).State
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
Indicates whether the connection device type is Host or Peer.Connected Device Type
The name of device that the port is connected to.Connected Device
Port firmware mode setting: Initiator, Target, Peer, or Suspended. Ports in Initiator mode
are connected to drive cages and ports in Target mode export to hosts. Suspended
Mode
mode is for target ports that have not yet been initialized by the system (this is rare).
Peer mode is for Ethernet ports.
The partner port, in Node:Slot:Port format. (Displayed only on destination systems.)Partner
The WWN of the partner port. (Displayed only on destination systems.)Partner WWN
Indicates whether the system is in a failover state. (Displayed only on destination systems.)Failover State
The detail pane contains the following information:
DescriptionFieldGroup
The port location in Node:Slot:Port format.PositionGeneral
The port’s World Wide Name.Port WWN
The node’s World Wide Name.Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
The rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps).
When there is no specified value, no connection exists.
Rate
The type of device that the port is connected to: Host or Peer.Connected Device
Type
The name of the system associated with the selected port.Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive cages
and ports in Target mode export to hosts. Suspended mode is for target ports that
Mode
have not yet been initialized by the system (this is rare). Peer mode is for Ethernet
ports.
The current state of the port.State
For iSCSI ports. The MAC address for the Ethernet interface.MAC (not shown)
For iSCSI ports. The Target Portal Group Tag for the iSCSI target portal group.TPGT (not shown)
The type of port connection: Host or Peer.Connection ModeSettings
(displayed for
Connection type or port connection setting: Loop or Point.Connection Type
FC and RCFC
ports)
Data transfer rate setting (for example, 1 Gbps). Auto indicates that the system
automatically selects the rate.
Configured Rate
Maximum rate of connection from the port.Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1 or Ack 0.Class 2
For fabric attached ports, indicates the VLUN change notification setting. When
set to Enabled, notices are generated and sent to the fabric controller. When set
to Disabled, no notification is sent.
VCN
Indicates whether the node's WWN is Enabled or Disabled.Unique Node WWN
If disabled, each I/O generates a separate interrupt to the HBA port driver rather
than generating one interrupt for multiple I/O completion.
Interrupt Coalesce
286 Using Peer Motion in HP 3PAR Management Console Manager