HP 3PAR Policy Server Administrator's Guide (QR483-96003, December 2012)

HP 3PAR Policy Server 4-11
Base Installation Actions
The following table lists and describes all actions included and managed in a base installation. Any custom
actions supported by your assets are not included below.
Table 4-1 Actions in a Base Installation
For this Action
Always Allow permits the Agent to do this
without asking for permission first Parameters
Alarms Send alarms to the HP 3PAR Enterprise Server.
(Custom alarms started as the result of a Start
Custom Alarm action, configured in a logic schema,
are not affected.) All alarms are included in the
action. You can select only Always Allow or Never
Allow for this action. In addition, filters do not work
for this action.
Alarm Name – set to a value of * by
default. You cannot change this value.
Create a Timer Allow the HP 3PAR Enterprise Server to create a
dynamic timer.
Name of the timer to create.
Data Item Values Send data item values to the HP 3PAR Enterprise
Server. (Data item values sent as the result of a
Write Data Item action, configured in a logic schema,
are not affected.) All data items are included in the
action. You can select only Always Allow or Never
Allow for this action. In addition, filters do not work
for this action.
Data Item Name – set to a value of *
by default. You cannot change this
value.
Disable a Script Disable a script from running when requested. Name of the script to disable.
Disable a Timer Disable a timer when requested. Name of the timer to disable.
E-mails Send e-mail notifications to the HP 3PAR Enterprise
Server. Except for the Send E-mail action configured
in a logic schema in Agent Builder, all e-mail
notifications are included in this action. You can
select only Always Allow or Never Allow for this
action. In addition, filters do not work for this action.
Email to – set to a value of * by
default. You cannot change this value.
Enable a Script Enable a script for operation when requested. Name of the script to enable.
Enable a Timer Enable a timer when requested. Name of the timer to enable.
Events Send events to the HP 3PAR Enterprise Server. All
events are included in the action. You can select
only Always Allow or Never Allow for this action. In
addition, filters do not work for this action.
Event Name – set to a value of * by
default. You cannot change this value.
Execute Start an application on the asset when requested
(whether an HP 3PAR Enterprise Server -based
request or Agent-initiated process)
Name(s) of the application(s) to run.