HP 3PAR Recovery Manager 1.1.0 Software for Microsoft Hyper-V User Guide (QL226-96343, June 2013)

Add-StoreServ
Add-StoreServ is used for each HP 3PAR StoreServ credentials.
• HP 3PAR StoreServ credentials are associated to a specific Microsoft Hyper-V
• This command is only required to initially set up credentials. The command is persisted by
RMH Server until the user removes it.
• The user can Add/Remove/Update HP 3PAR StoreServ credentials at any time during the
session
Preconditions
• The user must first login with Login-Rmh.
• HP 3PAR StoreServ name must not already exist for specified Microsoft Hyper-V
Syntax
Any optional parameters require square brackets [ ] around them.
Add-StoreServ -RmhServerName <RmhServerName> -HypervName <HypervName>
-StoreServName <StoreServName> -StoreServUsername <StoreServUsername>
-StoreServPassword <StoreServPassword> [-Verbose]
Table 21 Add-StoreServ parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
This is FQDN or IP address. Synonyms
are supported. The localhost is not
supported.
Required-HypervName
This is FQDN or IP address, etc.
Synonyms for HP 3PAR StoreServ are
supported.
Required-StoreServName
Note, if not provided, a dialog box will
pop up asking for credentials.
Required-StoreServUsername
Note, if not provided, a dialog box will
pop up asking for credentials.
Required-StoreServPassword
Displays progress messagesOptional-Verbose
Set-RmhPolicy
The set-RmhPolicy Cmdlet provides the ability to edit the default RMH Policy settings of a Virtual
Machine.
Preconditions
The user must first login with Login-Rmh.
Syntax
Any optional parameters require square brackets [ ] around them.
Set-RmhPolicy -RmhServerName <RmhServerName> -HypervName <HypervName>
-VmNameUuid <VmNameUuid> [-Expiry] [-Retention] [-SavedStateBackups]
[-Verbose]
46 Using PowerShell Snap-in Command Line Interface