HP 3PAR Service Processor Software 4.2.x Release Notes (QR482-96789)

Cannot view SPLOR contents using custom user account that was created by using
SPMAINT (Issue 100399)
You log in to the SP by using the 3parcust account, start SPMAINT, and then create a custom user
account. You then log out and launch SPOCC by using the custom account. When you run a SPLOR
and click View SPLOR contents, you receive the following error message:
Sorry, you are not permitted to view this directory.
However, if you create a custom user account by using SPOCC instead of SPMAINT, you are able
to view SPLOR contents as expected.
Incorrect time is set for VSP on Windows Hyper-V Server 2008 (Issue 100477)
When you use the SP Setup Wizard to configure the VSP on Hyper-V, if NTP is not configured and
you use the manual date/time selection method to select the time zone, the date and time are
incorrect. This issue occurs because after the SP setup process and reboot are complete, the date
and time of the SP are synced with the host system time. This is a known limitation of Hyper-V with
Linux clients.
Workaround: To work around this issue, use one of the following methods:
• Specify an NTP server rather than set the time zone manually.
• Set VSPs that are deployed from one Hyper-V server to the same time zone as that server.
• Set the Hyper-V time zone to UTC by using the date and time settings on the Windows desktop.
When you do this, the VSP is set to the correct time after the VSP reboot.
NOTE: This workaround is viable only if the Windows server is being used only as a Hyper-V
server for VSPs. This change will affect all of the users of the Windows server, and it may also
cause problems for any Windows virtual machines that are being deployed.
Known Issues with the Service Processor 9