HP 3PAR StoreServ 10000 Storage Physical Planning Manual

At installation time, the HP representative will supervise the delivery and unpacking of the equipment.
The representative must also review the crate with the customer to check that the shipping crates
have not been tampered with. When unpacking the equipment, verify the shipment is correct and
all equipment is delivered. Refer to the packing slip and the SKUs with the shipment.
NOTE: No part of the installation, from unloading the crated system from the delivery vehicle to
unpacking and placement, should be performed without the supervision of an HP representative.
This is a fundamental requirement for the safety of both the equipment and personnel.
Preparing a Site Installation Planning Guide
Prior to installation, the customer will complete a systems planning document such as the 3PAR
Systems Assurance and Site Planning Guide in cooperation with the local HP 3PAR Sales
Representative or HP 3PAR Systems Engineer.
The planning guide is a working document that contains the following information:
• Contact information for customer personnel and for HP technical sales, support, and service
personnel
• Implementation project plan
• Configuration information for the storage system to be installed, including system configuration
diagrams
• Shipping and delivery details and requirements
• Management workstation, service processor, and network information
• Description of the customer environment
• Volume and RAID level planning information
• Customer training project plan
• Additional notes and comments regarding installation
• Current support matrix
• System technical specifications
• Systems Acceptance Certificate
• Customer Services installation checklist
Cabinet Shipping Containers
Shipping container measurements are as follows:
• Cabinet crate (one per 2M rack cabinet): Height: 86 in. (218.5 cm) x Width: 42 in. (106.7
cm) x Depth: 48 in. (121.9 cm)
Approximate shipping weight: 1172 lb (531.6 kg)
• Drive magazine container (one per 3 drive magazines): Height 13 in. (33.1 cm) x Width 11
in. (28 cm) x Depth 27 in. (68.6 cm)
1
Approximate shipping weight: 33.8 lb (15.4 kg)
• Drive magazine container (one per 30 drive magazines): Height 38 in. (96.5 cm) x Width
29 in. (73.6 cm) x Depth 34 in. (86.4 cm)
Approximate shipping weight: 392 lb (177.8 kg)
• Drive magazine container (one per 50 drive magazines): Height 30 in. (76.2 cm) x Width
35 in. (88.9 cm) x Depth 45 in. (114.3 cm)
Approximate shipping weight: 618 lb (280.3 kg)
1. For systems shipped internationally and for systems with fewer than 25 drive magazines, magazines are shipped in
boxes. Each box contains three magazines.
14 General Site Planning