HP 3PAR StoreServ 10000 Storage Physical Planning Manual

Figure 52 Minimum Clearances for Four-Post Racks
10400 Rack Mounting Kits
Table 16 Mounting Racks and Kits
Cable Tray KitService ProcessorNode Chassis
Drive Chassis
Part Number 960-200106Part Number 960-200105Part Number 960-200104
Four-Post Shelf Kit
The four-post shelf kits allow the 10400 and DC4 drive chassis and components to be mounted in
a variety of four-post racks and rack cabinets. Each chassis or component requires its own mounting
kit. Stacking a chassis on top of another is not permitted.
Front and Rear Mounting
Four-post shelves are mounted to the front and rear rails of a four-post rack. Each side requires
two shelf halves and the corresponding mounting hardware. The shelf halves are expandable to
fit racks of different depths. Front shelf halves have left and right pieces, while the rear shelf half
can be used on either side of the rack.
When both the left and right side installation is complete, the equipment can be placed on the
shelves and secured to the RETMA rails.
Redundant Power Requirements
Each HP 3PAR Storage System component is supplied with redundant power supplies. The controller
nodes and drive chassis are designed to continue operating even when AC power is lost to one
of its supplies. For this feature to operate properly, each power supply line cord within an enclosure
must be attached to an independent electrical source, each controlled and protected by its own
circuit breaker. Multiple outlets in a power distribution unit or power strip do not constitute an
independent electrical source.
10400 Rack Mounting Kits 77