HP 3PAR StoreServ 10000 Storage Physical Planning Manual

Additionally, each line cord must be plugged into an outlet that is capable of supporting the entire
load of its enclosure.
CAUTION: In site planning, power distribution units are not provided with installation kit. Verify
the PDUs belonging to the customer meet minimum power requirements before powering on the
system. Special consideration must be given to this requirement. Failure to do so may result in the
overloading of the branch circuit if a power supply failed, which could shut down the storage
system and cause similar failures in all the equipment connected to that branch circuit.
CAUTION: AC line cords should be securely attached to the customer PDU's/outlets with
cord-retention mechanisms to prevent accidental disconnection during service activities. HP provides
cord retention mechanisms on HP power supplies but does not supply retention devices for
connection to the customer PDU's or outlets.
NOTE: See “Power Requirements” (page 28) for completed details on power requirements.
78 Third-Party Rack Mounting