HP 3PAR StoreServ 7000 Storage Site Planning Manual

Table 20 SP and Storage System Software Installation Checklist (continued)
Maximum supported speed and duplex setting:
Autonegotiate or
Custom duplex (half or full) and
Custom speed (10, 100, or 1000 MB/s)
Proxy server settings for Remote Support (if applicable):
Protocol
Address and port
Authentication information (optional)
System Support Information:
• Installation site information
• Customer information
Date and time:
Enter manually
Use NTP server information
Time zone region
New password to assign setupusr (for use with the system setup wizards)
NOTE: All passwords for the setupusr username must be between 7 and 32
characters in length and can consist of alphanumeric characters and the following
special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/).
New password to assign 3parcust (to access SPOCC)
NOTE: All passwords for the 3parcust username must be between 7 and 32
characters in length and can consist of alphanumeric characters and the following
special characters: period (.), plus (+), dash (-), equal (=), and forward slash (/).
HP 3PAR Storage System
Serial number
NOTE: The serial number is located on the back of your HP 3PAR storage system
next to the power switch for the node enclosure PCM. It begins with 16 (for example,
1624635).
StoreServ system name
IP address (IPv4 only)
Subnet mask
Gateway IP address
Date and time:
Use one of the following methods to configure the date and time:
• Copy from SP
• Enter manually or use NTP server information
• Time Zone
New password to assign 3paradm (to access the storage system)
NOTE: Passwords for the 3paradm username can include all printable characters
and be between 6-8 characters in length.
HP 3PAR SmartStart
Performing host configurations after using SmartStart for installation setup requires
available server to run Microsoft Windows 2008 R2 x64 Edition or 2012.
40 Storage System Installation Checklist