HP 3PAR StoreServ 7000 Storage Service Guide

3. Shutdown the node to be replaced:
a. Log into SPOCC and access Guided Maintenance for this storage system. In the Guided
Maintenance window, click Controller Node (see “Service Processor Onsite Customer
Care ” (page 5)). To log into SPOCC, go to https://<hostname or IP address>.
b. In the Node Rescue Task Information section, select the node to shut down from the Node
ID field, then click Shutdown Node.
c. In the Node Status Information section, click Refresh to confirm the node has been shut
down and the node is no longer in the cluster.
To view the Guided Maintenance pages:
i. Check the Node Status Information:
A. If the node to be serviced does not appear, close this window and proceed to
step 4.
B. If the node is listed, scroll to the bottom of the page.
ii. Use the Locatenode and Shutdownode commands to locate and shutdown the
node to be serviced.
iii. Select the link Replacement Instructions and Video to go to the HP Services Media
Library (SML).
NOTE: You may already have this window open.
iv. Navigate to your Storage System type:
• Product Type - Storage
• Product Family - 3PAR Storage Systems
• Product Series - HP 3PAR StoreServ 7000 Storage Systems
v. Launch FRU Remove/Replace and select the procedure for the controller node.
Controller Node (Node) Replacement Procedure 19