HP 3PAR StoreServ 7000 SmartStart 1.2 User's Guide (QL226-96854, June 2013)
Table Of Contents
- HP 3PAR StoreServ 7000 Storage SmartStart 1.2 Software User's Guide
- Part I Using SmartStart to Configure Storage
- Welcome
- 1 Prepare to Configure
- 2 Setting Up the Service Processor
- 3 Setting Up the HP 3PAR StoreServ Storage System
- 4 Connect to the HP 3PAR StoreServ 7000 Storage System
- 5 Configure the Hosts
- 6 Configure Storage
- 7 Install the HP 3PAR Management Console
- Part II Understanding Storage
- Part III Additional Resources
- Glossary
1. In the Policies group box, enable any of the following, as needed:
• Allow stale snapshots
• Restrict export to one host
• Enable zero detect (default)
• Retention Time — If you enable this, enter a value in the corresponding field, and then
select either days or hours.
• Expiration Time — If you enable this, enter a value in the corresponding field, and then
select either days or hours.
2. In the Geometry group box:
a. Enter the number of sectors per track or accept the default value.
b. Enter the number of heads per cylinder or accept the default value.
3. Click Next to view summary information, or click Finish.
Summary
Review the summary information, and then click Finish.
Export Virtual Volumes
Welcome to the Export Virtual Volumes Wizard
The Welcome screen describes the virtual volume export possibilities.
NOTE: If you click to select the Click here to skip this step in the future check box and later want
to reinstate the Welcome screen, delete this file:
C:\Users\<username>\SmartStart\preferences\preferences.xml
Export
1. In the General group box:
a. System - Select a system from the list.
b. Domain - Select a domain from the list. If not applicable, select <none>.
2. In the Virtual Volume group box:
a. Select either Virtual Volume or Virtual Volume Set.
b. From the virtual volume or virtual volume set list, select the volumes to export.
36 Configure Storage