HP 3PAR StoreServ 7000 SmartStart 1.2 User's Guide (QL226-96854, June 2013)
Table Of Contents
- HP 3PAR StoreServ 7000 Storage SmartStart 1.2 Software User's Guide
- Part I Using SmartStart to Configure Storage
- Welcome
- 1 Prepare to Configure
- 2 Setting Up the Service Processor
- 3 Setting Up the HP 3PAR StoreServ Storage System
- 4 Connect to the HP 3PAR StoreServ 7000 Storage System
- 5 Configure the Hosts
- 6 Configure Storage
- 7 Install the HP 3PAR Management Console
- Part II Understanding Storage
- Part III Additional Resources
- Glossary
You can create the following types of virtual volumes:
• Fully provisioned virtual volumes—Volume size is fixed. No separate license is required to
create fully provisioned virtual volumes.
• Thinly provisioned virtual volumes—Also known as Thin volumes, these volumes allocate space
on demand in small increments. To create Thin volumes, the HP 3PAR Thin Provisioning Software
license is required.
• Physical copies—A full copy of a volume. No separate license is required to create physical
copies.
• Virtual copies—A snapshot of a base volume that only records changes to the base volume.
To create virtual copies, the HP 3PAR Virtual Copy license is required.
43