HP 3PAR StoreServ 7000 Storage Service Guide

Table Of Contents

- -

1:1:1 target ready 2FF70002AC0185A6 21110002AC0185A6 host FC -

- -

1:1:2 target ready 2FF70002AC0185A6 21120002AC0185A6 host FC -

- -

1:2:1 initiator loss_sync 2FF70002AC0185A6 21210002AC0185A6 free FC -

- -

1:2:2 initiator loss_sync 2FF70002AC0185A6 21220002AC0185A6 free FC -

- -

1:2:3 initiator loss_sync 2FF70002AC0185A6 21230002AC0185A6 free FC -

- -

1:2:4 initiator loss_sync 2FF70002AC0185A6 21240002AC0185A6 free FC -

- -

1:3:1 peer offline - 0002AC8004BD rcip IP

RCIP1 - -

• showport -sfp to verify that the replaced SFP is connected and the State is listed as

OK:

cli% showport -sfp

N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM

0:1:1 OK HP-F 8.5 No No No Yes

0:1:2 OK HP-F 8.5 No No No Yes

0:2:1 OK AVAGO 10.3 No No Yes Yes

0:2:2 OK AVAGO 10.3 No No Yes Yes

1:1:1 OK HP-F 8.5 No No No Yes

1:1:2 OK HP-F 8.5 No No No Yes

1:2:1 OK HP-F 8.5 No No Yes Yes

1:2:2 OK HP-F 8.5 No No Yes Yes

1:2:3 OK HP-F 8.5 No No Yes Yes

1:2:4 OK HP-F 8.5 No No Yes Yes

Open the HP 3PAR Management Console

1. Under the Systems tree in the left panel, select the storage system to be serviced to connect.

2. On the Summary tab, click the Port link to open the port's tab.

3. Verify that State is listed as Loss Sync, the Mode is listed as Initiator, and the Connected

Device Type is listed as Free.

Figure 26 Port details

4. Contact HP Support for further verification.

SFP Repair 29