HP 3PAR StoreServ 7000 Storage Service Guide

To add the storage system to the SP:
1. Connect the maintenance PC to the SP.
2. In the SPMaint, type 3 and press Enter to select InServ Configuration Management.
SPXXXXX
1 SP Main
3PAR Service Processor Menu
Transfer media: ethernet Transfer status: No transfer yet
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> InServ Configuration Management
4 ==> InServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for an InServ
X Exit
3
3. Type 2 and press Enter to Add a new InServ.
SP - InServ Configuration Manipulation
Enter Control-C at any time to abort this process
1 ==> Display InServ information
2 ==> Add a new InServ
3 ==> Modify an InServ config parameters
4 ==> Remove an InServ
X Return to the previous menu
2
4. Enter the IP address of the InServ and press Enter.
SP - InServ Configuration Manipulation
Enter Control-C at any time to abort this process
Please enter the IP address of the InServ you wish to add
-OR -
Enter QUIT to abort:
<static.ip.address>
16:57:36 Reply='<static.ip.address>'
Adding <static.ip.address> to firewall rules on interface eth0
5. Enter a valid user credentials (CLI super-user name and password) to add the HP 3PAR InServ
and press Enter.
Please enter valid Customer Credentials (CLI super-user name and password) to add
the HP 3PAR InServ.
50 Installing Storage Software Manually