HP 3PAR StoreServ 7000 Storage Troubleshooting Guide

• Unable to set the storage system network configuration. An invalid
IPv4 gateway was specified.
This message displays in a dialog box. The error occurs if the storage system detects that the
defined IPv4 gateway address is invalid.
Click Back and specify a valid IPv4 gateway address.
• Unable to set the storage system network configuration. The specified
IPv4 gateway address is not reachable by using the specified storage
system IPv4 address.
This message displays in a dialog box. The error occurs if the storage system detects that the
defined IPv4 gateway address could not be reached.
Click Back and specify a valid IPv4 gateway address. If the error persists, contact HP Support.
For information about contacting HP Support, see “Contacting HP Support about System Setup”
(page 60).
• Unable to set the storage system network configuration. The storage
system IPv4 address cannot be the same as the IPv4 gateway.
This message displays in a dialog box. The error occurs if the storage system detects that the
defined IPv4 gateway address is the same as the configured IPv4 address.
Click Back and specify a different address for the IPv4 gateway address.
• Unable to set the storage system network configuration. The specified
address is already in use by another machine.
This message displays in a dialog box. The error occurs if the storage system detects that the
defined IPv4 address is already in use by another machine.
Click Back and specify a different IPv4 address.
• Unable to set the storage system network configuration. The storage
system could not be reached at the new IP address. Make sure your
network settings are configured correctly.
This error message displays in a dialog box with Retry and Cancel buttons. This error displays
when the SP is unable to reach the storage system at the new IP address.
Click Cancel to close the wizard, and then begin the setup process again.
• Unable to set the storage system network configuration. The storage
system did not recognize its new IP address as being validated.
This error message displays in a dialog box with Retry and Cancel buttons. This error displays
when the SP reaches the storage system at the new IP but fails to recognize that the SP was
able to do this.
Click Back and specify a valid IP address. if the error persists, contact HP Support.
For information about contacting HP Support, see “Contacting HP Support about System Setup”
(page 60).
Errors strings for the time setup progress step
• Unable to set the storage system NTP server. An invalid address was
specified.
This error message displays in a dialog box. This error displays if the storage system detects
that the NTP address is invalid.
58 Troubleshooting