HP 3PAR Host Explorer 2.1.0 User Guide (QR482-96029, December 2012)

3.2
Stopping the Host Explorer Process
HP 3PAR Host Explorer User Guide
Example output:
3.3 Stopping the Host Explorer Process
By default, the Host Explorer process starts at every reboot of the host.
 If you do not want the process running on the host, issue the TpdHostAgent stop
command.
3.4 Starting the Host Explorer Process
 To start the Host Explorer process, issue the TpdHostAgent start command.
3.5 Supporting Multiple Storage Systems on a Single Host
The HP 3PAR Host Explorer reports the information it collects to every HP 3PAR StoreServ
Storage system attached to the host. If a storage system is added or removed after the initial
installation of the HP 3PAR Host Explorer, a refresh is needed.
 To refresh the Host Explorer process, issue the TpdHostAgent refresh command.
3.6 Supporting VMware Virtual Machines with iSCSI
The HP 3PAR Host Explorer supports VMware Virtual Machines connected to HP 3PAR StoreServ
Storage systems with iSCSI connections. For information about supported operating systems on
VMware Virtual Machines, refer to the HP 3PAR OS Configuration Matrix available on SPOCK.
Printing the status of 3PAR Host Explorer daemon:
3PAR Host Explorer is running..
The current time interval values are:
Value is PushInterval=86400
 default
Value is RefreshInterval=60  default