HP 3PAR Management Console 4.3.0 Software User's Guide (QL226-96337, December 2012)

Set Up Connections
1. Click on a port in the destination system.
2. Select Pick a pair for <destination port>, and then select the port you want paired with the
destination port. (Peer ports will display as bold.)
NOTE: If the host ports are not already configured, the user can configure them in the Port
Parameters area.
NOTE: At any time, you can check host and peer port WWNs by clicking “Show Port
WWNs” (page 227) on the Set Up Connections screen.
226 Using the Peer Motion Manager