HP 3PAR Management Console 4.3.0 Software User's Guide (QL226-96337, December 2012)

The Summary tab provides the following information:
DescriptionFieldGroup
Port location in Node:Slot:Port format.PositionGeneral
The designated port label.Label
Port World Wide Name.Port WWN
Node World Wide Name.Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps).
When there is no specified value, no connection exists.
Rate
Type of device that the port is connected to: Free, Disk, Host, Peer, RC, or
InServ.
Connected Device
Type
Name of device that the port is connected to, e.g. host1, cage0.Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive
cages and ports in Target mode export to hosts. Suspended mode is for
Mode
target ports that have not yet been initialized by the system (rare). Peer mode
is for Ethernet ports.
Current state of the port: Ready, Login Wait, Loss Sync, or Offline.State
For iSCSI ports. The Media Access Control address for the Ethernet interface.MAC
For iSCSI ports. The Target Portal Group Tag for the iSCSI target portal group.TPGT
The throughput in KB/sec. (Not shown for RCFC or Persistence ports.)Total Data
Throughput
Resources
The type of port connection.Connection ModeSettings (displayed
for FC and RCFC
ports)
Connection type or port connection setting (Loop, Point, or Loop-point). When
the port is set to Loop-point, both loop and point-to-point connections are
enabled.
Connection Type
Viewing System Ports 31