HP 3PAR Management Console 4.3.0 Software User's Guide (QL226-96337, December 2012)

The following information is provided:
DescriptionFieldGroup
The location of the SFP within the system.PositionGeneral
Current condition of the SFP.State
Manufacturer of the SFP.Manufacturer
Part number of the SFP.Part Number
Serial number of the SFP.Serial Number
SFP's revision level.Revision
Maximum speed allowed by the SFP.Max Speed
Displays whether the SFP has been tested and if the SFP is supported.Qualified
Displays whether the transmit laser is disabled.TX Disable
Displays whether the transmit laser has a problem.TX Fault
Displays whether the receive end of the SFP is experiencing a loss of signal from
the host or drive cage.
RX Loss
Displays whether the SFP receive power is low.RX Power Low
Displays whether the SFP is DDM-capable (Digital Diagnostic Monitoring).DDM Support
Identifies the monitored parameters (temperature, voltage, TX bias, TX power,
and RX power).
TypeDDM
The unit of measure used for the monitored parameters.Unit
The current measured value.Value
The manufacturer's recommended lower-limit warning level.Low Threshold
Warning
The manufacturer's recommended upper-limit warning level.High Threshold
Warning
The manufacturer's recommended lower-limit alarm level.Low Alarm
Threshold
The manufacturer's recommended upper-limit alarm level.High Alarm
Threshold
Hosts
The host port information is presented on the Hosts tab.
The following information is provided:
DescriptionColumn
The ID of the host.Host ID
The name of the host.Host Name
The domain in which the host resides.Domain
The hosts WWN.WWN
The hosts location in N:S:P (Node:Slot:Port) format.Port
Viewing System RCFC Ports
To view system Remote Copy over Fibre Channel (RCFC) port information:
Viewing System Ports 41