Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000633-01, June 2007)

18 Access Gateway Administrator’s Guide
53-1000633-01
Determining the mapping and port status
4
switch:admin> ag --mapshow
N_Port Configured_F_Ports Current_F_Ports Failover Failback
-------------------------------------------------------------------------
0 9;10 None 1 1
17 None None 1 1
18 3;4 None 1 1
19 None None 1 1
20 None None 1 1
21 1;2;11;12 1;2 1 1
22 5;13;14 5;9 1 1
23 6;15;16 6;10 1 1
-------------------------------------------------------------------------
To display an N_Port map
1. Connect and log in to the switch.
2. Enter the ag
--mapshow command and specify the port number to display the N_Port failover
and failback policies and the mapped F_Ports.
switch:admin> ag --mapshow 0
N_Port : 0
Failover(1=enabled/0=disabled) : 1
Failback(1=enabled/0=disabled) : 1
Current F_Ports : 2;8;
Configured F_Ports : 2;
DISPLAYING THE PORT STATUS
This section explains how to determine the ports status.
To display the port status
1. Connect and log in to the switch.
N_Port Number of the port.
Failover Indicates whether or not the failover policy is enabled (1) or disabled
(0) on the N_Port.
Failback Indicates whether or not the failback policy is enabled (1) or
disabled (0) on the N_Port.
Current F_Ports Shows the F_Ports that are currently connected to the fabric on this
N_Port.
In the case of failover, the Current F_Port and Configured F_Ports
differ. For example (shown below), 8 failed over to this port from
another port.
Configured F_Ports Indicates the ports which are mapped to this N_Port.