Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000633-01, June 2007)

32 Access Gateway Administrator’s Guide
53-1000633-01
Troubleshooting
C
Failover is not working Failover disabled on N_Port. Verify that failover and failback policies are enabled, as follows:
Enter the ag
--failoverShow command with the <port_number>
operand.
Enter the ag
--failbackShow command with the <port_number>
operand.
Command returns “Failback (or Failover) on N_port <port_number> is
supported.”
If it returns, “Failback (or Failover) on N_Port <port_number> is not
supported.” See “Managing the failover and failback policies” on
page 21.
Access Gateway is mode
not wanted
Access Gateway must be disabled. Disable switch using the switchDisable command.
Enable Access Gateway mode using
the ag
--modeDisable command.
Answer yes when prompted; the switch reboots.
Log in to the switch.
Display the switch settings using the switchShow command. Verify
that the field switchMode displays Fabric OS native mode.
TABLE 5 Troubleshooting (Continued)
Problem Cause Solution