Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000633-01, June 2007)

Access Gateway Administrator’s Guide 33
53-1000633-01
Appendix
D
Access Gateway Commands
This appendix contains the commands for Access Gateway mode in the Fabric OS 5.3.0 release.
System messages can be found in the Fabric OS Message Reference.This appendix uses the same
conventions as the Fabric OS Command References.
Access Gateway commands
ag
Enables and manages Access Gateway mode to perform AG specific operations.
Usage
ag <action> [arguments]
Synopsis ag --show
ag --modeshow
ag --modeenable
ag --modedisable
ag --mapshow [N_Port]
ag --mapset <N_Port> <F_Ports>
ag --mapadd <N_Port> <F_Ports>
ag --mapdel <N_Port> <F_Ports>
ag --failovershow [N_Port]
ag --failoverdisable <N_Port>
ag --failoverenable <N_Port>
ag --failbackshow [N_Port]
ag --failbackdisable <N_Port>
ag --failbackenable <N_Port>
Description Use this command to enable and disable Access Gateway mode, to display the current
configuration and state, to configure and display the F_Port to N_Port mapping, and to configure
N_Port failover and failback policies. AG only supports embedded switch platforms that use the
GoldenEye ASIC.
Operands This command has the following operands:
--show Displays the N_Ports and F_Ports that are currently online, whether they have
failover enabled, and displays their mapping.
--modeshow Displays current mode of the switch, either Access Gateway or native Fibre
channel switch (FOS) mode.
--modeenable Enables Access Gateway mode for a switch.
--modedisable Disables Access Gateway mode for a switch.
--mapshow [N_Port]